The Easy Steps To Electric Water Heater Installation

Installing a brand new water heater in your home is one thing that most do-it-yourselfers can do, specifically new one you buy can be an exact fit, in every single way, with the old one you remove. In that position, it’s important that you start assembling your project by taking careful measurements with the old one, examine the water connection, electrical connection each other dimension too. Let’s take a look at what you need to caused by get this job done. – Reliant Plumbing

Taking Measurements Is vital

Get a tape measure and obtain the height, width, quantity of watts and gallon capacity from the water heater you have now. Of course, pipes can be extended longer, if your new appliance is shorter, so can the electrical connections if required, but most of the time you may get an almost exact match in the local building supply store, this makes your water heater installation easier. Make sure you turn off the power at the fuse box, and after that turn off the water supply before beginning.

There Is A Drain Valve Towards the bottom Of The Tank

Hopefully you have a sewer drain in your basement or utility room the location where the water heater is located or you may have to use a bucket and make some trips backwards and forwards to empty the water from the old heater. A hose will fit the drain for the heater, if you’re above walk-out you can drain the water outside. Carefully disconnect the wires and clean water connections, then haul that old appliance out. There are instructions online regarding how to make a BBQ grill out of your old metal tank with a search.

Bring The newest Water Heater In And Examine Any Differences In Connections

Have a look at the connections, water inlet, water outlet, positive electric, negative electric as well as perhaps a ground wire. Make sure if they’re not exactly the same which you have the right conversion adapters to do the job. Most electric water heaters may have the same 3/4 inch water pipes that will be exactly the same as the old ones. Many times it’s a good idea to buy new flexible pipes to counteract leaks caused by corrosion on the old ones.

After You’ve Connected The river, And Electric Make sure Everything

It’s very important to check both the electrical and water connections before you start to fill the tank. Don’t ever turn on the electricity before the tank is loaded with water, this could ruin the weather inside immediately. Your water heater installation is nearly complete, turn the water inlet valve on full, then turn on a hot water faucet in the home and run it until all of the air has been eliminated from the system, and then some more to make certain. Double check everything once more, then turn on the circuit breaker to transmit power to the new heater.

Replacing a well used water heater is a fairly simple job, however it is something that needs to be done properly to avoid problems. Just be sure you check and make sure everything several times on the way and you’ll do just fine. – Reliant Plumbing

Advertisements